Delta Design CAD functionality provides a full cycle of PCB development:

• Formation of a database of radio-electronic components and keeping it up to date
• Development of electrical circuit diagrams
• Carrying out simulation of analog and digital circuits; analysis of simulation results
• PCB design development
• Positioning of components and conducting semi-automatic and automatic PCB routing
• Release of design documentation (in accordance with standards)
• Issue of production documentation, including for automated production lines
• Preparation of data for compiling a list of purchased products and materials necessary for the implementation of the project

Delta Design CAD helps to increase the productivity of electronic device developers and has a number of advantages:

• Data control and integrity.  The data is stored in a transactional DBMS, which ensures its integrity.
• End-to-end design.  The system provides a full cycle of designing radio electronic devices.
• Optimized library.  The concept of "Datasheet as a whole" entry allows you to maintain a series of electronic components of the same type (for example, a series of resistors) as a single component, which simplifies library administration and ensures its integrity and consistency.
• Intelligent schematic editor.  Automatic laying of circuit circuits along the optimal route. Automatic creation of ports at the ends of chains. Move components, conductors, ports and buses while maintaining connections.
• Extensive possibilities for setting rules and technological restrictions.  The rules are set with the necessary detail, depending on the complexity of the project. The rules are maintained using the principle of inheritance of the specified parameters along the hierarchy of circuits, layers and regions (areas) on the board.
• ESKD support.  The templates and design styles included in the system allow you to draw up documentation in accordance with the requirements of GOST.
• Innovative modeling tools.  Environment modeling tools allow you to effectively simulate both analog and digital processes occurring in circuits. The accuracy and speed of modeling tools is superior to analogues.
• Possibility of interactive and automatic tracing.  Possibility of interactive and automatic tracing. The routing of conductors on a printed circuit board can occur in manual, interactive or fully automatic mode. The combination of modes allows you to determine the optimal topology of the printed circuit board, developed in Delta Design CAD, and minimize the cost of its design.
  PCB routing in Delta Design TopoR
• Convenient intuitive interface.  The system interface is built on the basis of the latest methodological developments and modern software technologies. It provides a comfortable experience and reduces the number of design errors, allowing you to perform only the correct actions.